It is possible to cut through a control line with multiple channels and wire bumpers.
This week we have played around with different control lines in our workshop. Even the toughest with two bumper wires are possible to cut through with our method.
It looks like the Precision Drilling Tool is able to do more than just drill a hole or two.
In our workshop we have successfully cut tubing with the Precision Drilling Tool. Replacing the drill bit with a suitable mill the tool can both drill through the tubing, mill a slot or do a full cut of a tubing.
To make an effective tool for P&A applications a new tool with an adjustable feed mechanism need to be made.
Follow the link below to see a short video from the lab testing:
On September 2. 2015 Agat Technology performed a successful operation with the Precision Drilling Tool (PDT) in an offshore well in the North Sea. More than 50 holes with Ø 5,1 mm were drilled with the same bit on depths from 1180 - 3340 m in a 5 1/2" tubing.
New tools are in production and will be ready for the market soon.
Drill-bit diameter may be varied depending on customer requirements. The Precision Drilling Tool can be run in combination with CCL and Tractor.
For further information or a demonstration of PDT please e-mail: firstname.lastname@example.org or call +47 51 81 71 00
PRECISION DRILLING TOOL
The onshore qualificaton tests for PDT is now completed. After a pilot test in an offshore weel, the tool will be ready for the marked.
AGAT IS PRESENT AT ONS 2014!
Agat is presenting the PDT tool at ONS 2014. The tool is sponsored by Conoco Phillips.
Come visit us at Hall C Stand 351!
SUCCESSFUL TEST OF THE PDT TOOL
May 12th 2014 Agat Technology had a successful test of the prototype of the new Precision Drilling Tool. Several holes were drilled in a 5 ½” casing.
The tool is fully electrical and run on standard wireline. It will operate in casing/liner dimensions from 4 ½” to 7”, and are able to drill through 30mm wall thickness.